How to do self test on VCI , Keypad, CANdi and RS232 with GM Tech2 Scanner?

How to do GM Tech 2 scanner self test step-by-step?

1.VCI self test

2.Keypad self test

3.CANdi self test

4.RS-232 self test

 

Follow the instruction in detail…

 

Part 1: Tech2 VCI self test

Insert the GM card

Connect the adapter and ready for the self test

Go to the main menu and select F4: Tool options

F3: Self test

Exit to continue

Select the function for self test

Here, press F2: Automated VCI

The VCI module self test result

 

Passed VCI selftest.

 

 

Part 2: GM Tech II Keypad self test

Go to the Tech 2 menu and select F4: Tool options

Then F3: Self test

Before running the Tech 2 self test:

(1) Candi cannot be connected

(2) Aldl loopback should be connected (GM3000109)

(3) Failure to follow these instructions may invalidate the self test

F3: Selectable main pcb

Press Keypad

And press key

Note: In the last image, the actual key pressed is F0 and the final result is PASS – that’s normal

 

When you test the keypad, press F0-F1-F2-F3-F4-F5-F6-F7-F8-F9-EXIT-ENTER-in a good order! DO NOT SKIP ANY ONE.

 

 

Part 3: Tech 2 scan tool CANDI module self test

VERY IMPORTANT: Pls make sure of the connection of the OBD adapter, OBD main cable, CANdi module, Tech 2 scan tool and the power supply — ALL should be good

 

The power should be connected by the OBD port for CANdi self test.

F4: Tool options

F7: CANdi diagnostics

F0: POST result

Test status

F1: Self test

CANdi self test result

Pass selftest

There are two test results for CANdi module.

The one is Figure 8, and the other is Figure 10.

 

Part 4: GM Tech2 scanner RS232 self test

Check the connection before R232 self test

F4: Tool options

F3: Self test

 

Exit to continue

F3: Selectable main PCB

F2: Rs-232 loopback

Rs232 test: Passed!